Solid State Logic 82BN0M01B - Manual (Page 44)

Page 40 Nucleus User Guide
Mixdown Mode
When mixing down, Nucleus can be used to insert external processing to the stereo master by pressing the MIXDOWN switch
above the HP LEVEL control. In mixdown mode, the monitor inputs replace the input channels as the source for the channel
insert sends. The insert return is routed to the channel outputs in the normal way, allowing the processed signal to be re-
recorded within the DAW.
Note that in mixdown mode, none of the monitor controls affect the insert send or return. However, the monitoring
continues to function normally.
External and iJack
A choice of external sources can be fed to the monitors and headphones, enabling auditioning without having
to use up channel inputs. The EXTERNAL XLR sockets, located on the back panel, allow a balanced line-level
stereo source to be connected whilst the iJack socket, a 3.5mm stereo jack also located on the back panel,
allows external sources such as MP3 players to be connected. To listen to either input, press the EXT switch
above the MONO L and MONO R switches.
The External and iJack inputs are internally blended; both inputs are selected with the one EXT switch.
The external source(s) can replace the normal monitor source, or be added to it: Press the ∑ switch (above the
EXT switch) to sum the monitor sources together, or leave it unselected to replace the normal monitoring with
the external signal.
Take care to avoid creating a feed-back loop by feeding the processed signal to the stereo master within
the DAW!
M
ETERING
The pair of meters at the top of the centre section can be used to meter three different signals:
Monitors The left and right monitor blend of channel input and DAW return. The meters are sourced after the
BLEND pot but before the MONITOR LEVEL control. This is the default meter source.
Note that when the iJack is the selected monitor source, the meters will still show the input and return blend level rather
than the iJack level.
Inputs Press the MIC switch below the meters to display CHANNEL 1 on the left meter and CHANNEL 2 on
the right meter. This signal is sourced from after the channel’s insert send and return, just before
the signal is sent to the DAW via the USB Soundcard.
Mixdown Return With the MIC button active, press the MIXDOWN button above the HP LEVEL control to meter the
left and right mixdown signals. This meter source is after the insert send and return, just before the
signal is sent back to the DAW via the USB Soundcard.
See above for an explanation of mixdown mode.