Sony 3-286-590-12(1) - Manual (Page 17)

17
Ge
tt
in
g
S
ta
rte
d
To remove your camcorder from the
Handycam Station
Turn off the power, then remove the
camcorder from the Handycam Station
holding both your camcorder and the
Handycam Station.
To charge the battery pack using only
the AC Adaptor
Turn off the power, then connect the AC
Adaptor to the DC IN jack on your
camcorder.
b Notes
• Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.
To remove the battery pack
Turn the POWER switch to OFF (CHG).
Slide the BATT (battery release) lever and
remove the battery pack.
b Notes
• When you remove the battery pack or
disconnect the AC Adaptor, make sure that the
(Movie) lamp/ (Still) lamp (p. 20)/
ACCESS lamps (p. 29) are turned off.
• When you store the battery pack, fully discharge
the battery before storing it for an extended
period (see page 107 for the details of storage).
To use a wall outlet (wall socket) as a
power source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
To check the remaining battery
(Battery Info)
Set the POWER switch to OFF (CHG), then
press DISP/BATT INFO.
With the v mark
on the right
DC IN jack
Open the
jack cover
POWER switch
DC plug
BATT (battery
release) lever