Swisher ZT13536 - Manual (Page 16)

SERVICE / ADJUSTMENTS
BELTS
Clutch drive belt replacement
1. Disconnect tension idler from tension
bracket.
2. Remove belt from mower pulley and
electric clutch.
3. Install new belt onto electric clutch and
mower pulley and check for proper
routing and clearance.
4. Reconnect idler tension bolt to tension
bracket.
Mower deck belt replacement
1. Remove clutch drive belt. See previous
procedure.
2. Remove belt covers.
3. Disconnect idler tension spring.
4. Remove deck belt.
5. Install new belt, check for proper routing
and clearance.
6. Reinstall clutch drive belt.
16
Transaxle belt replacement
1. Remove clutch drive belt. See clutch belt
replacement previous page.
2. Disconnect wiring from electric clutch.
3. Disconnect idler spring from tension bracket.
4. Remove bolt and washer from bottom of
electric clutch and slide clutch from engine
crankshaft, set aside.
5. Remove belt from transaxles and engine
pulley.
6. Install new belt. Check for proper routing
and clearance.
7. Reinstall electric clutch carefully aligning
keyed portion of clutch and keyway in
crankshaft. Reinstall bolt and washer.
Washer is “cupped” be sure to place “cupped”
side of washer towards the clutch body.
8. Reconnect tension idler to tension bracket.
9. Reconnect wiring harness to electric clutch.
10. Reinstall clutch drive belt. See clutch belt
replacement previous page.
4219- Engine Drive
Belt
3694- Blade Drive
Belt
BA50- Transmission Belt