Sony MZ-R700DPC - Manual (Page 26)

26
2
Press <MENU, repeatedly until “SYNC REC” flashes in the
display, and then press ENTER.
“SYNC” does not appear if optical cable is not connected to the
recorder.
3
Press <MENU, repeatedly until “SYNC ON” flashes in the
display, and then press ENTER.
4
Press and slide REC to the right.
The recorder stands by for recording.
5
Play the source sound.
The recorder starts recording when it receives the playing sound.
To stop recording, press x.
z
• You cannot pause manually during synchro-recording.
• When there is no sound from the player for more than 3 seconds during
synchro-recording, the recorder goes into the standby mode automatically.
When the sound comes from the player again, the recorder resumes synchro-
recording. If the recorder is kept in the standby mode for 5 minutes or longer,
the recorder stops automatically.
• For longer recording, follow step 1 of “Recording for long times” (page 24)
to select the recording mode, and then do the procedure of synchro-
recording.
Notes
• Do not change SYNC REC setting while recording. Recording may not be
done properly.
• Even when there is no recorded sound on the sound source, there may be
cases when recording does not pause automatically during synchro-recording
due to the noise level emitted from the sound source.
• If a silent portion is encountered for 2 seconds or more during synchro-
recording from a sound source other than a CD or an MD, a new track mark
is automatically added at the point where the silent portion ends.
SYNC REC
SYNC indicator