Sennheiser EK 3041-U - Manual (Page 11)

37
11 Power supply
Your EK 3041-U receiver can be powered from different power sources. The
adaption to these power sources is via the plug-in connector at the bottom of
the receiver and the corresponding accessories.
The EK 3041-U can be powered
•
directly via the camcorder with 12 V or 5.6 V or
• via the GA 3041-B power adaptor which is attached to the special housing
12 Putting the receiver into operation / Switching the receiver on
If the receiver is inserted in the slot-in facility of a camcorder, the receiver is
switched on as soon as the camcorder is put into operation. The receiver’s
ON/OFF switch
ባ
is then locked. If the ON/OFF switch is pressed, „Loc“
appears on the display.
If the receiver is mounted into a special housing for external attachment to
camcorders, press the ON/OFF switch
ባ
to switch the receiver on. After
approx. two seconds, the display indicates the receiving frequency or its
respective channel number.
Two bargraphes indicate the received RF signal (upper bargraph: „RF“) and
the deviation (lower bargraph).
13 Switching the receiver off
To switch the receiver off, press the ON/OFF switch
ባ
for approx. one
second until „OFF“ briefly appears on the display.
Please wait at least two seconds before switching the receiver on again.