Remote control battery installation, Remote control operating range, Press firmly and slide the battery cover off – Sanyo PDG-DSU30 User Manual
Page 10: Put the cover back, Install new battery into the compartment
10
Remote Control Battery Installation
Press firmly and slide
the battery cover off.
1
Put the cover
back.
3
Install new battery into the
compartment.
2
Remove the old Lithium
coin cell and install new
one (CR2025). Ensure
that the side with a “+”
is facing up.
To ensure safe operation, please observe the following precautions :
■
Use CR2025 type battery.
■
Avoid contact with water or liquid.
■
Do not expose the remote control to moisture or heat.
■
Do not drop the remote control.
■
If the battery has leaked in the remote control, carefully wipe the case clean and
install new battery.
■
Risk of an explosion if battery is replaced by an incorrect type.
■
Dispose of used battery according to the instructions.
Remote Control Operating Range
Point the remote control
toward the projector (In-
frared Remote Receiver)
when pressing any button.
Maximum operating range
for the remote control is
about 23.0’ (7m) and 30° in
front of the projector.
23.0’ (7m)
Approx.15°
M
nO
2
-
L
i
CELL
3
V
OL
T
SJ
AP
AN
H
CR2025
3
V
OL
T
S
CR2025
M
3
V
OL
T
S
CR2025