Shindaiwa SP210 - Manual (Page 2)

2
This manual contains information for the proper assembly,
operation and care of your SP210 sprayer. Carefully read and
follow the instructions contained in this manual before operat-
ing your sprayer.
Specifications
Unpack the following
items shipped in your
sprayer box:
■ Wand
■ Tank Assembly
■ Owner’s/Operator’s
Manual
Net Weight ....................................................... 4.8 pounds (2.2 kg)
Tank Capacity ...................................... 2.0 U.S. gallons (7.6 liters)
Tank Material ..................................... UV Protected Polyethylene
Fill Opening Diameter .................................... 3.6 inches (92 mm)
Pump Type/Material .................................... Piston/Polyethylene
Operating Pressure ........................ 10-45 psi (0.7-3.15 kg/sq.cm)
Wand Assembly Length .......................... 27.5 inches (698.5 mm)
Hose Length .............................................. 69 3/4 inches (1771 mm)
Nozzle Installed ............................................ Red Adjustable Cone
Specifications subject to change without notice.
Prepare to Assemble Introduction
Push the wand into the trigger valve and secure with screw
cap. Hand tighten to prevent leakage.
CAUTION!
Do not overtighten!
Trigger
Valve
Wand Screw
Cap
Assembling the Spray Wand
IMPORTANT!
After assembling the sprayer, fill the tank with clear water,
and lay it on its side. Check for leaks. Return sprayer to its
upright position. Pump the sprayer 10-40 times or until the
pressure relief valve is released and check for leaks. Most
leaks can be stopped by tightening the appropriate connec-
tion or fitting. Any leaks must be stopped prior to filling the
sprayer with chemicals.
Wand
Nozzle
Trigger
Valve
Tank
Pump
Handle
Cylinder
Cap
Carry
Strap
Lid
Pressure
Relief Valve
SH IND AIW A O WN ER 'S/O PER ATO RS M AN UA L
SP2 10 S PAY ER
WARNING!
Always relieve pressure from the sprayer tank by pulling
the pressure relief valve before removing the tank lid.
᭨
᭨