Woodstock M1104 - Manual (Page 12)

-10-
M1104, M1105, M1106 Heavy-Duty Bench Grinder
SET
UP
Test Run
Once your machine is mounted and assembled, you should
perform a test run to make sure it works properly.
To perform a test run, do these steps:
1. Make sure all tools are removed from the grinder
area.
2. Make sure the switch is in the OFF position.
3. Plug the grinder into the power source.
4. Turn the grinder ON. Under normal conditions, the
grinder will make a humming noise, with only minor
vibration.
— If you suspect any problems, immediately turn
the grinder OFF and refer to Page 15 to trouble-
shoot and correct any problems before starting the
grinder again.
— If the source of an unusual noise or vibration is not
readily apparent, contact our technical support
for help at (360) 734-3482 or contact us online at
[email protected].
DO NOT investigate problems or adjust
the Heavy-Duty Bench Grinder while
it is running. Wait until the machine
is turned OFF, unplugged and the
spindle has come to a complete stop
before proceeding!