Sun Microsystems SUN FIRE X2100 - Manual (Page 48)

2-14 Sun Fire X2100 Server Getting Started Guide • April 2006
2. Insert the Sun Fire X2100 Server Supplemental CD into the DVD drive and type:
Where /mountpoint is the directory to which the CD is mounted and operating_system
is the type of Linux installed on the server.
■ If the directory does not exist, the CD did not automount. You need to mount the
CD and change to the correct directory as shown in
Step 3 and Step 4 .
■ If you were able to access the operating_system directory, go to Step 5 .
3. If the CD does not automount, open a terminal window and mount the CD by
typing the following command:
Where /mountpoint is the appropriate mount point for the OS and optical drive type.
For example:
4. Change to the / mountpoint/drivers/linux/operating_system directory.
Where /mountpoint is the directory that the CD is mounted to, and operating_system
is the type of Linux installed on the server.
For example:
5. Run the installation script by typing the following command:
This script is not executed if the X server is running.
■ If the script exits and you receive an error message, go to Step 6 .
■ If the script executes correctly, go to Step 7 .
6. If the script exits and you receive an error message, do the following steps to
disable the X server:
cd / mountpoint/drivers/linux/operating_system
# mount -o ro /dev/cdrom / mountpoint
# mount -o ro /dev/cdrom /mnt/dvdrom
# cd /mnt/dvdrom/drivers/linux/red_hat
# sh install.sh