Sennheiser 500 Series - Manual (Page 20)

Using the devices
18
If you cannot establish a transmission link between transmitter and receiver:
̈
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
̈
If necessary, read the chapter “If a problem occurs ...” on page 30.
Switching the devices on/off
EM 500 receiver
To switch the receiver on :
To switch the receiver to standby mode :
̈
If necessary, deactivate the lock mode (see page 22).
To completely switch the receiver off :
̈
Disconnect the receiver from the mains by unplugging the mains unit from the wall
socket.
It is vital to observe the following notes:
̈
Make sure that the desired frequencies are listed in the enclosed frequency
information sheet.
̈
Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
200
KM500
ew500 G3
E
MHz
¶
̈
Briefly press the STANDBY button
¶
.
The receiver switches on and the “ Receiver Parameters ” standard display
appears.
̈
Keep the STANDBY button
¶
pressed until “ OFF ” appears on the display panel.
When in the operating menu, pressing the STANDBY button
¶
will cancel your entry
(ESC function) and return you to the current standard display.