Samsung SW-208 - Manual (Page 9)

Technical Specifications
15
SAMSUNG continually strives to improve its products. Both the design
specifications and these user instructions are thus subject to change without
notice.
CD-R (write mode)
300 KB/sec. (2X), 600 KB/sec. (4X)
1 200 KB/sec. (8X)
Disc
Error rate
Rear Panel
Front Panel
Operating
Environment
General
Reliability
Drive
Performance
Disc diameter
Disc types supported
in read mode
Data transfer rate
Access time (1/3 stroke)
Laser
Slide mechanism
Spindle motor
Load mechanism
Eject button
Indicator (LED)
Headphone output
Volume control
Dimensions
Net weight
Operations
Storage
Required power
Interface connector
Audio output
Jumper block
MTBF
CD-DA, CD-ROM mode 1, CD-ROM XA mode 2, Form 1, Form 2,
CD-Plus, CD-Extra, Photo-CD (Single, Multi-session), Video CD
ready, Enhanced CD, CD-I/FMV,
12 cm or 8 cm
Erasing disc types CD-RW
Read mode
120 ms (typical)
Semiconductor laser
Stepping motor
Brushless motor
Tray. DC motor (Soft Eject).
Mode 1: 1 block/10 12 , Mode 2: 1 block/10 9
Auto eject or Auto inject
Green when playing or recording a disc
Stereo mini-jack (Ø 3.6 mm) 0.60±20% (vrms) 33 Ω
Dial type
+5 VDC: 1.5 A (max.), +12 VDC: 1.5 A (max.)
ATAPI (EIDE)
Line out 0.70 ± 20% (vrms): 47 K Ω
Device configuration jumper
Temperature: 5~45°C Humidity: 10~80%
149 (W) x 42 (H) x 200 (D) mm (including bezel)
860 g
125 000 POH (20% duty)
100 ms (typical)
Item SW-208
Temperature: -25~55°C Humidity: 10~90%
Solving Technical Problems
14
The CD-R/RW drive is not
detected by the computer.
After installing the CD-R/RW
drive, the PC gets slower.
◆ Check that the power, audio and IDE cables are
correctly connected to the computer.
◆ Change the IDE cable and reconnect it to the computer.
Preferably, connect a second IDE cable to the CD-R/RW
drive in master mode; see page 7 for further details.
◆ Check the position of the jumper in the master/slave
select terminal.
Problem Meaning / Solution
The CD-R/RW drive is not
recognized by MS-DOS. ◆ Reinstall the device driver or update it with the latest
version by downloading it from the Samsung Web site.
The CD-R/RW drive is not
detected by Windows. ◆ This case may occur when there is a Windows
installation problem; reinstall Windows.
No sound is heard from an
audio CD. ◆ Check whether the audio cable is correctly connected
to the sound output terminal on the CD-R/RW drive and
the sound card CD-IN terminal.
◆ Check that the sound card is operational.
◆ Adjust the volume control.
A CD is not read or is read too
slowly. ◆ Install the latest version of the device driver.
◆ Check whether the CD is of good quality and clean it,
if necessary.
When the MPEG software plays
a Video CD, the pictures are not
regular and the running speed is
too slow. ◆ Adjust the size of the replay screen.
◆ After checking the display resolution, adjust it, if
necessary.
The Disc is not in message is
displayed even though a disc
has been inserted. ◆ The computer may not recognize the disc if you start
playback too quickly after inserting the disc.
Open and close the disc compartment and try again.
◆ Clean the disc and try again.
The CD-R/RW drive is not
detected after it is connected to
a sound card. ◆ The interface mode of the sound card is AT-BUS.
You must therefore connect the CD-R/RW drive to the
IDE port on the PC mother board, rather than to the
sound card, or install an IDE-compatible sound card.
The disc compartment will not
open. ◆ Check that the power cable is correctly connected.
◆ Power off and disconnect the PC. Insert a pin or
unfolded paper clip in the emergency hole and push
firmly until the disc compartment opens.
300 KB/sec. (2X), 600 KB/sec. (4X)
4,800 KB/sec. (max.), PIO Mode 4,
DMA Mode 2
CD-R, CD-RW Disc types supported
in write mode
CR-RW (write mode)
CD-RW :
CD :