Shark SSG-503537E/G - Manual (Page 15)

SHARK SSG • 8.914-337.0 / 97-6134 • Rev. 8/07
15
PRESSURE
W
ASHER
Tr
oub
leshooting Guide
TROUbLEShOOTING
PRObLEM POSSIbLE CAUSE SOLUTION
LOW OPERATING
PRESSURE Faulty pressure gauge Install new gauge.
Insufficient water supply Use larger supply hose; clean filter at water
inlet.
Old, worn or incorrect spray nozzle Match nozzle number to machine and/or
replace with new nozzle.
Belt slippage Tighten or replace; use correct belt.
Plumbing or hose leak Check plumbing system for leaks. Retape
leaks with teflon tape.
Faulty or misadjusted unloader valve Adjust unloader for proper pressure. Install
repair kit when needed.
Worn packing in pump Install new packing kit.
Fouled or dirty inlet or discharge
valves in pump Clean inlet and discharge valves.
Worn inlet or discharge valves Replace with valve kit.
Obstruction in spray nozzle Remove obstruction.
Leaking pressure control valve Rebuild or replace as needed.
Slow engine RPM Set engine speed at proper specifications.
Pump sucking air Check water supply and possibility of air
seepage.
Valves sticking Check and clean or replace if necessary.
Unloader valve seat faulty Check and replace if necessary.
bURNER WILL
NOT LIGhT
(continued on
next page)
Little or no fuel Fill tank with fuel.
Improper fuel or water in fuel Drain fuel tank and fill with proper fuel.
Clogged fuel line Clean or replace.
Plugged fuel filter Replace as needed.
Mis-adjusted burner air bands Readjust air bands for clean burn.
Little or no fuel pressure from fuel
pump Increase fuel pressure to specification and/or
replace fuel pump. Test with pressure gauge.
Faulty burner transformer Test transformer for proper arc between con-
tacts. Replace as needed.
Disconnected or short in electrical
wiring All wire contacts should be clean and tight. No
breaks in wire