Sony DVP-NC675P - Manual (Page 24)

C:\Documents and Settings\PC3\Desk-
top\My Document\3091202111 DVP-
NC675P\SOURCE\DVP-
NC675P_GB\01US05GET-UC.fm master page=left
DVP-NC675P
3-091-202-11(1)
24
Connecting to an AV amplifier (receiver) with a digital input jack having
a Dolby Digital, or DTS decoder and 6 speakers
This connection will allow you to use the Dolby Digital, or DTS decoder function of your AV
amplifier (receiver).
z Hint
Use connection when connecting to 7 or
more speakers (6.1ch or more).
Notes
• After you have completed the connection, be sure to
set “DOLBY DIGITAL” to “DOLBY DIGITAL”
and “DTS” to “ON” in Quick Setup (page 25).
• In order to listen to DTS sound tracks, you must
use these connections. DTS sound tracks are not
output through the LINE OUT L/R (AUDIO)
jacks, even if you set “DTS” to “ON” in Quick
Setup (page 25).
• When you connect an amplifier (receiver) that
conforms to the 96 kHz sampling frequency, set
“48 kHz/96 kHz PCM” in “AUDIO SETUP” to
“96 kHz/24 bit” (page 69).
D
S VIDEO OUT
LINE OUT COMPONENT
VIDEO OUT
VIDEO P R Y P B
NORMAL
PROGRESSIVE
DIGITAL OUT
COAXIAL OPTICAL
PCM/DTS/ DOLBY DIGITAL
LINE OUT
R-AUDIO-L
PCM/DTS/
DOLBY
DIGITAL
DIGITAL OUT
COAXIAL OPTICAL
Front (R)
Front (L)
Rear (R)
AV amplifier (receiver) having
a decoder
Subwoofer Center
Optical digital cord
(not supplied)
Remove jack cap
before connecting.
[Speakers]
CD/DVD player
l : Signal flow
[Speakers]
Rear (L)
to optical digital
input
to DIGITAL OUT
(COAXIAL)
Coaxial digital cord
(not supplied)
to DIGITAL OUT
(OPTICAL)
to Coaxial digital
input
or
D