Samsung DVD-1080P8 - Manual (Page 16)

ENG- 16
C
O N N E C T I O N S
1
Using V ideo/Audio cables, connect the VIDEO (yellow)/AUDIO
(red and white) OUT jacks on the rear of the DVD player to the
VIDEO (yellow)/AUDIO (red and white) IN jacks of your TV.
2
T urn on your DVD player and TV.
Note
- Noise may be generated if the audio cable placed too close to the power cable.
- If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 17 to 18)
- The number and position of the jacks may vary depending on your TV set. Please refer to the user's manual
of your TV.
- If there is one audio input terminal on the TV, connect it to the [AUDIO OUT][left] (white) jack of the DVD
player.
- If you press the VIDEO SEL. button when the DVD Player is in stop mode or no disc is inserted, the Video
Output mode changes in the following sequence: (I-SCAN
➝ P-SCAN).
RED
WHITE
YELLOW
RED
WHITE
YELLOW
Audio Cable
(Included)
Video Cable
(Included)
3
Set the V ideo Output to I-SCAN in the Display Setup menu.
(See pages 51 to 53).
You can also use the
VIDEO SEL. button to change the V ideo
Output mode. (See page 16)
4
Press the input selector button on your TV remote control until
the Video signal from the DVD player appears on the TV
screen.
Connecting to a TV (V ideo)