Sim2 Multimedia HT 250 - Manual (Page 4)

HT 200/250
6
4 SAFETY WARNINGS
Please follow carefully the warnings listed below, to ensure
safe and long term performance of your projector.
Fig. 7
Only replace the safety fuse (on the power socket at the
rear of projector) with a fuse identical in type and
characteristics (T 3.15A H)
(Fig. 8) .
250 V
T 3.15A H
1 2 3
4
Fig. 8
Do not switch on your projector when flammable liquids
or fumes are present. Do not pour or drop fluids in the
vents
(Fig. 9) .
Fig. 9
Do not use the projector when the room temperature is
above 35°C (95°F)
(Fig. 10) .
10
20
30
40
50
60
Fig. 10
ƽ
CAUTION: A special EVC socket on the
projector’s rear panel will allow connection to
the optional Remote Input Interface (a special
cable is required).
This is not to be confused with a VESA “Plug
& Display”
Never connect a computer to this socket, as
the projector and the computer may be
damaged (Fig.4).
Connect the projector to a power supply with a nominal
voltage within the following values: 100-240 Vac, 50/60 Hz,
earthed
(Fig. 5) .
100-240 Vac
50/60 Hz
Fig. 5
The mains plug is the disconnect device. Take care when
installing, that the mains plug and socket outlet are easily
accessible. Never pull on the cable to take it out of the socket.
If the system is unlikely to be used for a number of days,
disconnect the power cable and other apparatus connected to
it; also disconnect the aerial cable (where applicable).
Fig. 6
To save energy, switch off the projector by using the power
switch at the rear; in stand-by (red light on) the projector
continues to draw a minimal amount of power
(Fig. 7) .
Fig. 4