Sony VPL-CS1 - Manual (Page 23)

VPL-CS1
4-074-278-11 (1)
C:\MUN\Data\FM\VPL-CS1\VPL-
CS1.nouhindata\407427811VPLCS1WW\02GB-
VPLCS1WW\04SET.fm masterpage:Left
23 GB
Projecting
S
e
tti
n
g U
p
an
d Pr
o
jec
ting
To turn off the power
1
Press the I / 1 key.
“POWER OFF? Please press I /
1 key again.” appears to confirm that you
want to turn off the power.
A message disappears if you press any key except the I /
1 key, or if you do not
press any key for five seconds.
2
Press the I / 1 key again.
The ON/STANDBY indicator flashes in green and the fan continues to run for
about 90 seconds to reduce the internal heat. Also, the ON/STANDBY
indicator flashes quickly for the first 30 seconds. During this time, you will not
be able to turn the power back on with the
I /
1 key.
3
Unplug the AC power cord from the wall outlet after the fan stops running
and the ON/STANDBY indicator lights in red.
When you cannot confirm the on-screen message
When you cannot confirm the on-screen message in a certain condition, you can
turn off the power by holding the
I /
1 key for about one second.
Do not unplug the AC power cord while the fan is still running; otherwise, the fan will
stop even though the internal heat is still high, which could result in a breakdown of the
projector.
To stow the leg on the bottom
If you are not going to use the projector, close the front cover first and then fold
up the leg on the bottom of the projector manually at the end.
On air filter
To maintain optimal performance, clean the air filter every 300 hours.
Note
Note