Sonance Navigator K2 - Manual (Page 4)

N A V I G A T O R K 2
S P E C I F I C A T I O N S
SONANCE • 212 AVENIDA FABRICANTE • SAN CLEMENTE , CA 92672-7531 • TEL : 800-582-7777 • 949-492-7777 • FAX : 800-538-5151 • 949-361-5151
©2002 SONANCE . ALL RIGHTS RESERVED . SONAMP IS A REGISTERED TRADEMARK OF SONANCE . 33-2989 12/02
ALL SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE .
TAKE THE TOUR AT WWW . SONANCE . COM
Navigator K2 In-wall Keypad
Navigator K2 In-wall keypad
with LCD touch screen
Navigator Harbor
Multi-Zone A/V Controller
High contrast, high viewing angle 64 x 128
pixel, black & white LCD touch screen with
white LED backlighting
• Six interchangeable hard source buttons
• Built-in IR receiver
• One IR Output (200mA)
• One half-duplex RS485 port
(RJ-45 connection for future
upgradability, not active at this time).
• One power sense input
• One speaker relay trigger output
• One speaker relay status input
• One keypad sync I/O port for keeping
multiple keypads synchronized to the
same page/source
• K2 Program Manager intuitive & robust
PC software for programming and
configuration
• Includes toggles, programming cable,
and white bezel (Additional faceplates in
Black, Ivory, and Almond colors sold
separately).
• Overall Dimensions (W x H x D): 4.5” x
4.5” x 1.83” (114mm x 114mm x 46.5mm)
• In-wall Dimensions (W x H x D): 3.66” x
3.23” x 1.83” (93mm x 82mm x 46.5mm)
• Inputs: Audio – 6 gold RCA, 6 looping jacks
47k; Video-6 gold RCA, 6 buffered looping
jacks 75Ohms; IR/Keypad- 5 position
removable connector; Paging-3.5mm mono
mini-plug with variable level control; OPTO
isolated 5-24VDC trigger Input
• Outputs: Audio-6 stereo RCA 600Ohms;
Video-6 composite RCA 75Ohms; 6 com
mon IR, 6 zone, 1 linking (3.5mm mono
mini-plug for all IR outputs)
• Frequency Response: 20Hz-20kHz +/-0.5dB
• Input Dynamic Range: 90dB
• Volume Control Range: 68dB
• THD: Less than 0.02% 20Hz-20kHz
• Signal to Noise Ration: less than -98dB
(A weighted)
• Preamp Gain: +12dB at maximum volume
• Maximum Signal Output: 9V RMS into
10kOhms load
• Dimensions (W x H x D): 16-3⁄4” x 5-5/8” x
12-5/8” (425mm x 143mm x 321mm)
• Weight: 20 lbs (9 kg)
• Also available in rack mount version
Sonamp 1230
12 Channel Amplifier
Sonamp 1250MKII
12 Channel Amplifier
• All Channels Driven Power Output: 30
Watts per channel @ 8Ohms; 45 Watts per
channel @ 4Ohms
• Total Harmonic Distortion: 0.03% 20Hz-
20kHz @ 8Ohms; 0.10% 20Hz-20kHz @
4Ohms (45 WRMS)
• I.M. Distortion (SMPTE 4:1) @ 8Ohms:
0.01% @ 30 Watts
• Signal to Noise Ratio: -100dB below rated
output (A-weighted)
• Input Sensitivity: 700 millivolt for 30 watts
RMS @ 8Ohms
• Input Impedance: 20kOhms
• Power Consumption: 1400 Watts,
maximum 4Ohms full power
• Fuse: 10A AG
• Dimensions (W x H x D): 16-3/4" x 5-5/8" x
14-1/4" (425mm x 143mm x 362mm)
• Weight: 38 lbs (17 kg)
• Also available in rack mount version
• All Channels Driven Power Output: 50
Watts per ch x 12 @ 8 Ohms; 75 Watts per
ch x 12 @ 4 Ohms; 100 Watts per ch x 6 @
8 Ohms bridged.
• Dynamic Headroom: +1.9dB x 12 @ 8
Ohms; +1.8dB x 12 @ 4 Ohms; +3.5dB x 6
@ 8 Ohms bridged
• Total Harmonic Distortion: 0.03% 20Hz-
20kHz @ 8 Ohms, 50 Watts; 0.06% 20Hz-
20kHz @ 4 Ohms, 75 Watts; THD less than
0.01% @ 1 kHz 4 Ohms, 75 Watts
• I.M. Distortion (SMPTE 4:1) @ 8 Ohms:
0.01% @ 50 Watts, 8 Ohms
• Signal to Noise Ratio: -100dB below rated
output (A-weighted)
• Input Sensitivity: 700 millivolts for 50 Watts
RMS @ 8 Ohms
• Input Impedance: 20kOhms
• Power Consumption: 1800 Watts maximum
@ 4 Ohms, full power; 10 Watts standby
• Fuse: 15A MDA, 250V
• Dimensions (W x H x D): 16-3/4" x 9-1/2" x
16-1/2" (425mm x 243mm x 420mm)
• Weight: 55 lbs (25 kg)
• Also available in rack mount version
Use the Sonance Navigator Harbor and the Sonamp ® 1230, or Sonamp 1250MKII
for seamless integration with the Navigator K2.
Sonance Navigator K2 system hook up
diagram for a sample whole house system!
Additional wall plate colors are also
available in: Almond, Black, and Ivory!
Navigator Harbor
Sonamp 1230