Sears C944.414460 - Manual (Page 7)

7
locale where such regulations exist, you
are legally responsible for maintaining
the operating condition of these parts.
Failure to do so is a violation of the law.
Refer to
CUSTOMER RESPONSIBILITIES
TABLE in the MAINTENANCE section.
STANDARDS: This saw is listed by
Underwriter’s Laboratories, Inc., in ac-
cordance with:
CSA Z62.1--03 Chain Saws -- Occupa-
tional Health and Safety
CSA Z62.3--96 Chain Saw Kickback
Occupational Health and Safety
ASSEMBLY
WARNING: Before using chain
saw, ensure all fasteners are secure.
CARTON CONTENTS
Check carton contents against the fol-
lowing list.
Model C944.414460
S Chain Saw (fully assembled)
S Chain adjustment tool (bar tool)
S 2-cycle engine oil (bar oil not included)
S Carrying case
Examine parts for damage. Do not use
damaged parts.
If you need assistance or find that parts
are missing or damaged, contact your
Sears Service Centre
NOTE: It is normal to hear the fuel filter
rattle in an empty fuel tank.
Your unit has been factory tested and
the carburetor precisely adjusted. As a
result you may smell gasoline or find a
drop of oil/fuel residue on the muffler
when you unpack the unit.
ASSEMBLY
Your saw is fully assembled; no
assembly is necessary.
OPERATION
KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW.
Compare the illustrations with your unit to familiarize yourself with the
location of the various controls and adjustments. Save this manual for future ref-
erence.
Chain Adjustment Tool
(Bar Tool)
Front Handle Front Hand Guard
Chain
Bar Oil
Fill Cap
Starter Rope
ON/STOP
Switch
Starter Housing
Fuel Mix Fill Cap
Muffler Bar Sprocket
Hole
Bumper
Spike
Direction
of Chain
Travel
Guide Bar
Chain Brake Nuts
Chain Brake
Choke/Fast
Idle Lever
Throttle
Trigger
Rear
Handle
Cylinder Cover
Throttle
Lock--out
Adjusting
Screw