Woodstock SHOP FOX M1001 - Manual (Page 15)

-13-
M1001 6" x 26" Vertical Mill
SE
T
U
P
The SHOP FOX ® Model M1001 has been carefully pack-
aged for safe transporting. If you notice the machine has
been damaged, please contact your authorized SHOP
FOX ® dealer immediately.
Unpacking
SET UP
NOTICE
When ordering replacement parts, refer
to the parts list and diagram in the back
of the manual.
Figure 3. Model M1001.
Figure 4. Toolbox contents.
The following is a description of the main components
shipped with the SHOP FOX ® Model M1001. Lay the
components out to inventory them.
Wooden Box Contents (Figures 3 & 4) Qty
A. Milling Machine ............................................1
B. Toolbox ......................................................1
Toolbox Contents (Figure 4) Qty
C. 3" Shell Mill with Arbor ...................................1
D. Handwheels .................................................2
E. Handwheel Handles .......................................4
F. Drawbar with Locking Nut ...............................1
G. Spare V-Belts ...............................................2
H. 220V ON/OFF Switch ......................................1
I. Open End Wrenches 17/19mm & 12/14mm ...........2
J. T-Slot Bolts M12-1.75 x 40 ...............................2
K. Screwdriver .................................................1
L. Phillips Head Screwdriver ................................1
M. Hex Wrenches 3, 4, 5, & 6mm ..........................4
Inventory parts not shown:
• Power Feed Instruction Manual .........................1
If any parts are missing, find the part number in the back
of this manual and contact Woodstock International, Inc.
at (360) 734-3482 or at [email protected]
Inventory
SUFFOCATION HAZARD!
Immediately discard all plastic bags
and packing materials to eliminate
choking/suffocation hazards for chil-
dren and animals.
B
C
E
F D
H
J
G
I
M
L
K