SECO-LARM USA Covert Ceiling-Mount Camera EV-6120-N3WQ - Manual (Page 3)

ENFORCER Covert Ceiling-Mount Camera
SECO-LARM U.S.A., Inc. 3 SECO-LARM U.S.A., Inc.
33 3
1. Run a 12VDC power supply wire and a video cable
with a male BNC connector through the ceiling to
where the camera is to be mounted.
2. Temporarily connect the camera to the 12VDC
power supply. Do not cut the DC jack or female
BNC plug as the warranty will be voided. If
needed, use the included SECO-LARM DC plug
with terminal block.
3. Temporarily connect the camera’s female BNC jack
to the video cable’s male BNC plug. While watching
the monitor, hold the camera by hand against the
ceiling where it is to be mounted, then twist the
camera until it is certain that this mounting location
is correct. Use a pencil to mark the location of the
two screw holes in the bracket.
4. If the camera angle needs to be adjusted, remove
the camera module and loosen the adjustment
Installation:
screws. Rotate the camera module to the
correct angle. Tighten the adjustment screws
and replace the camera module in the housing.
5. To adjust the camera for bottom view, remove
the camera module and loosen the adjustment
screws. Rotate the camera to face the bottom
viewing hole. Tighten the adjustment screws
and replace the camera module in the housing.
6. Disconnect the 12VDC power supply and
video cable.
7. Mount the camera to the ceiling using the two
included mounting screws.
8. Reconnect the 12VDC power supply and video
cable. Turn the monitor on and make sure the
camera is sending the proper video signal.
9. Do a final test of the video camera and monitor.
1. Please read this manual carefully and keep it for
future reference.
2. Use the camera within given temperature and
electricity limits.
3. Do not point the camera at the sun. Heat could
damage the camera, even when not in use.
4. Do not mount the camera in areas exposed to
radiation, strong magnetic fields, or strong
electrical signals.
5. Do not open or disassemble the camera. There
are no field serviceable parts inside.
6. Do not drop the camera or subject it to strong
vibrations.
Before Starting:
Mounting
screws
Side viewing
hole
Mounting
screws
Bottom viewing
hole
Overview:
DC Plug with
terminal block
Important:
Do not cut the DC jack or the female BNC
connector as this will void the warranty.
Camera
housing
Female BNC
connector
DC jack
Camera
module
Camera module
mounting screws
Adjustment
screw
Adjustment
screw
Bottom Viewing Angle:
Adjust the camera to face the bottom viewing hole.