Samson C03 - Manual (Page 7)

Using the Optional SP01 “Spider” Shock-Mount
SP01
SHOCK MOUNT
THREADED
COLLAR
THUMB
SCREW
0 0 -10dB -10dB
7
THREADED
COLLAR
0 0 -10dB -10dB
Using the Optional SP01 Shock-Mount
1
2
For additional isolation, the C03 can be fit-
ted on the optional SP01 “Spider” shock
mount. Follow the steps below the to
install the SP01.
• First, screw the SP01 shock mount
onto your mic stand or boom arm. If
you’re using a US 5/8” mic stand or
boom, remove the Euro adapter.
• Remove the C03 swivel mount by
rotating the threaded collar counter-
clockwise as shown in figure 1.
• Install the C03 into the SP01 by fitting
the microphone into the center of the
web, positioning the C03 onto the bot-
tom mounting plate.
• Secure the SP01 by reinstalling the
threaded collar, rotating clockwise
until tight. (Figure 2)
• Now, loosen the thumb screw to
adjust the angle of the microphone
and position the C03 to the desired
location. Once set, tighten the thumb-
screw to secure the microphone in
place.
Note: Be careful not to cross thread
or over tighten the threaded collar or
thumb screw.