Sennheiser Freeport - Manual (Page 8)

7
Connecting the microphone/instrument cable
The audio input is designed for the connection of both the ME 2 clip-on
microphone and instruments (e.g. guitars).
̈
Connect the 3.5 mm jack plug from the microphone/instrument
cable to the 3.5 mm jack socket
»
.
̈
Check the setting of the MIC / INST slide switch
²
which allows you
to switch between microphone and instrument operation. If
necessary, readjust the setting.
̈
Use the GAIN control
¾
to adjust the transmitter sensitivity so that
the receiver receives a good audio signal (no distortion and no
background noise).
Attaching and positioning the microphone
Use the microphone clip to attach the ME 2 clip-on microphone to
clothing (e.g. tie, lapel). Conduct the microphone cable so that noise due
to friction is avoided and make sure that the antenna and the cable do
not cross. The omni-directional microphone picks up sound equally from
all directions. However, it should be attached as close as possible to the
sound source.
Attaching the bodypack transmitter to clothing
̈
Use the supplied belt clip
¸
to attach the bodypack transmitter to
clothing. Make sure that the antenna is at least 1 cm away from the
body and is not kinked.
Switching the bodypack transmitter on/off
̈
Press the ON / OFF button
³
to switch the bodypack transmitter on
or off. If the bodypack transmitter is switched on, the red LED
·
lights up.
Note:
Remove the battery when the transmitter will not be used for
extended periods of time.
Selecting and changing a channel
̈
Switch off the transmitter before you change the channel.
̈
Use a small screwdriver to set the channel selector switch
º
to the
desired channel. You can switch between four different channels.
When you switch on the bodypack transmitter again, it will transmit
on the new channel (“Selecting a channel”).
freeport_514013_0808_Sp5.book Seite 7 Mittwoch, 26. November 2008 2:16 14