Sirius Range Hoods SUF1 - Manual (Page 7)

4
Figure 6
Connect the appropriate length of
ducting to the fan exhaust point and
join up with the ducting to the exte-
rior.
Do not fix the ducting to the range
hood exhaust outlet with screws -
use duct tape. Use duct tape on all
joints.
Re-Circulating Requirements
If the unit is to be used in the
re-circulating mode, fit the carbon
filter after the installation is complete
(refer to Figure 7B).
The carbon filter fits in behind the
aluminium grease filter. Ensure that
the plastic tabs on the carbon filter
are facing outwards otherwise it will
be difficult to remove it later for
replacement.
A short length of ductwork must
be connected from the exhaust
outlet on the fan to wherever the
air is to be exhausted (refer to
figure 8 A and B) Allow sufficient
space to connect the ductwork to the
top of the exhaust outlet on the fan
housing. Do not fix the ducting to
the range hood exhaust outlet with
screws, use duct tape. Duct tape
should be used on all joints.
Figure 7
Ensure that the plastic flaps at the
exhaust outlet for the fan move
freely and have not become jammed
or stuck.
Figure 8