Sony DPP-FP35 - Manual (Page 37)

37 GB
Troubleshooting
Symptom
An image is
printed with
borders even if I
select borderless
print option.
An image is not
printed in correct
colors.
Preview image does
not reflect the print
settings in the
“Graphics” tab of
the “Sony DPP-FP35
Properties” dialog
box.
Print quantity
specified in the
“Paper/Output” tab
of the “Sony DPP-
FP35 Properties”
dialog box does not
take effect.
Check
• Are you using an
application software
other than Picture
Motion Browser?
• Is “Exif Print” checked
in the “Graphics” tab
of the “Sony DPP-FP35
Properties” dialog
box?
• Is “ICM” selected in
the “Graphics” tab of
the “Sony DPP-FP35
Properties” dialog
box?
Cause/Solutions
c When using an application other than the
Picture Motion Browser, an image might be
printed with borders even if you select
borderless print. If this occurs, do either of the
following to print an image without borders:
– When you can set print range with an
application, set an image to be printed
fully in the print range even if it is printed
over the range.
– Set a larger value in the “Enlarge/Reduce”
text box in the “Paper/Output” tab of the
“Sony DPP-FP35 Properties” dialog box.
(
.page 28)
– If borders remain on the right and bottom
sides of a printed image even after you set a
larger value, check “Upper left reference”.
c The Exif Print setting in the “Color
reproduction/Picture quality” section
supports the Picture Motion Browser only.
To print from other application, uncheck
“Exif Print”.
c The ICM setting may be valid only when
you are using an ICM-compliant application.
Check to see if the application software you
are using supports ICM.
c The print settings adjust the printer itself
and cannot influence the preview image.
c Depending on the application software you
use, the print quantity setting of the application
software may have priority over the setting
specified in the printer driver dialog box.