Sennheiser Diversity Receiver EK 100 G3 - Manual (Page 18)

17
Adjusting settings via the operating menu
Via the “ Tune ” menu item, you can set a receiving frequency to be stored
in the current channel or you can select a different channel in the
frequency bank “ U ” and assign this channel a receiving frequency.
Setting a receiving frequency for the current channel
Selecting a channel and assigning this channel a frequency
̈
Set the desired frequency (MHz and kHz section) as described in the
previous chapter.
̈
Press the rocker button until the “ Tune ” menu item appears.
̈
Press the SET button.
The MHz section of the receiving frequency of the channel is
highlighted.
It is vital to observe the notes on frequency selection on page 19.
̈
Press the rocker button to set the MHz section of the
frequency.
̈
Press the SET button to confirm the MHz section of the
frequency.
The kHz section of the frequency is highlighted.
̈
Press the rocker button to set the kHz section of the frequency.
̈
Press the SET button to confirm the frequency.
“ Stored ” appears on the display panel. The “ Tune ” menu item
appears again.
̈
Press the rocker button until the “ Tune ” menu item appears.
̈
Press the SET button and keep it pressed until the frequency
bank is highlighted.
̈
Press the rocker button to set the channel.
̈
Press the SET button to confirm the channel.
The frequency (MHz section) is highlighted.
SET
Tu n e
B.Ch: U1. 1
Tu n e Advanced Menu
Tune
“Stored”
823.925 MHz
823 .925 MHz
B.Ch: U1. 1
823. 925 MHz
SET SET
SET
Select the frequency
bank and confirm
Select the channel;
store the setting
Call up “Tune”
(special function)
SET
SET
SET
Tu n e
B.Ch: U1 . 1 B.Ch: U5. 1
Tu n e Advanced Menu
Tune
“Stored”
823.925 MHz
823.925 MHz 823.925 MHz
SET SET
SET
Select the frequency
bank and confirm
Select the channel;
store the setting
Call up “Tune”
(special function)
SET