Sony 6900DP - Manual (Page 55)

Ad
dition
al I
n
fo
rm
atio
n
masterpage:Right
lename[E:\SEM_Janet\DATA_HT-
950DP\J9041386_25497361115950DPUS\2549736111\GB09ADD_HT-5950DP-U.fm]
55 US
model name1[HT-5950DP]
model name2[HT-6900DP]
model name3[HT-9900M]
[2-549-736-11(1)]
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
receiver by the message. Refer to the following
table to solve the problem.
DEC. EROR
Appears when the signal which the receiver cannot
decode (ex. DTS-CD) is input when “DEC. XXXX”
in the CUSTOMIZE menu is set to “DEC. PCM”.
Set to “DEC. AUTO”.
PROTECT
Irregular current is output from the speakers. The
receiver will automatically turn off after a few
seconds. Check the speaker connection and turn on
the power again. If this problem persists, consult
your nearest Sony dealer.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy the
problem (page 18). However, note that all
memorized settings will be reset to their factory
settings and you will have to readjust all settings
on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver’s memory
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(Model of area code U only)
With 6 ohm loads, both channels driven, from
120 – 20,000 Hz; rated 90 watts (STR-K9900P)/
70 watts (STR-K5900P) per channel minimum
RMS power, with no more than 0.7% total
harmonic distortion from 250 milliwatts to rated
output.
Amplifier section
Power Output
1)
Model of area code U
(6 ohms 1 kHz, THD 10%)
STR-K9900P: FRONT
2)
: 140 W/ch
CENTER 2) : 140 W
SURR
2)
: 140 W/ch
SURR BACK
2)
: 140 W
STR-K5900P: FRONT
2)
: 110 W/ch
CENTER
2)
: 110 W
SURR
2)
: 110 W/ch
SURR BACK
2)
: 110 W
Model of area code CA
(6 ohms 1 kHz, THD 0.7%)
STR-K5900P: FRONT
2)
: 70 W/ch
CENTER 2) : 70 W
SURR
2)
: 70 W/ch
SURR BACK
2)
: 70 W
(6 ohms 1 kHz, THD 10%)
STR-K5900P: FRONT
2)
: 110 W/ch
CENTER
2)
: 110 W
SURR
2)
: 110 W/ch
SURR BACK
2)
: 110 W
1) Measured under the following conditions:
2) Depending on the sound field settings and the
source, there may be no sound output.
To clear See
All memorized settings page 18
Customized sound fields page 37
Specifications
Area code Power requirements
U, CA 120 V AC, 60 Hz
continued
GB01COV_HT-5950DP-U.book Page 55 Thursday, January 13, 2005 3:28 PM