Sony MAV-555 - Manual (Page 7)

2.
VIDEO SERVER SETUP
a.
The SONY MAV unit must have the following or higher software versions: V1.1
b.
Clips loaded from the front panel of the MAV will not be displayed on the ST300.
c.
SETUP MENU/RECORD MODE. Crash and Lockout are the only modes supported.
3. LOAD A CLIP
a.
Select VTR. Connection must be to the Player port in order to load existing clips.
b. Press
[CLIP LIST]. The CLIP LIST indicator will turn on. The display prompts:
“WHEEL-scroll files, ENTER-enter file ID”
c.
Turn the Wheel to scroll through the list of available CLIPs.
OR
ENTER a numeric file ID, using the numeric keypad.
d. Press
[LOAD] to load the desired clip.
e.
Repeat steps a - d until clips are loaded into the desired VTRs.
Set the GANG mode, if required. (Refer to the Function Table for Details.)
f. Press
[ESC] at anytime to exit CLIP LIST.
4. LEARN ON THE ST300
a.
LOAD a clip as described above on the ST300.
b.
Set IN and OUT points if desired.
c.
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE].
OR
By manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
d.
Press [SHIFT] + [MARK] to initiate the LEARN.
The ST300 will save loaded CLIP ID and current IN time to the selected Cue Point. The
display shows:
e. Press
VTR[1], VTR[2], VTR[3] or VTR[4] to select the VTRs.
f. Press
[MARK]. The ST300 will: LEARN (save) the current configuration, which
consists of: Cue Point, CLIP IDs, In Times and Ganged VTRs.
Select VTR:
Mark-Learn, ESC-Cancel
7 4000CL-MAV, 250 Clip Fast Access System, for Sony MAV-555, with PBIO option