Sunbeam SNM1502RAS - Manual (Page 5)

5
SAVE THESE INSTRUCTIONS
As required by UL the following statements must be incorporated in the User Manual for Safety:
a.
This appliance should be serviced only by qualified service personnel. Contact nearest authorized
service facility for examination, repair, or adjustment.
b. Either: i) When cleaning surfaces of door and oven that comes together on closing the Door, use only
mild, nonabrasive soaps or detergents applied with a sponge or soft cloth, or ii)When separate
cleaning instructions are provided. See door surface cleaning instructions on (specific page or section
to be included).
UNPACKING INSTRUCTIONS
Carefully remove oven from carton.
• SAVE THE CARTON AS IT MAY MAKE INSTALLATION EASIER.
Remove:
1. All packing materials from inside the oven cavity; however, DO NOT REMOVE THE WAVEGUIDE
COVER, which is located on the ceiling in the oven cavity. Check to see that there are Installation
Instructions, Wall Template, Top Cabinet Template, bag of Installation Hardware, Charcoal Filter and
Exhaust Damper Assembly. Read enclosures and SAVE the Owner’s Instructions.
2. The feature sticker from the outside of the door, if there is one.
Check the oven for any damage, such as misaligned or bent door, damaged door seals and sealing surfaces,
broken or loose door hinges and latches and dents inside the cavity or on the door. If there is any damage, do not
operate the oven and contact your dealer.
See Installation Instruction for more details.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and
grounded.
WARNING – Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to
whether the appliance is properly grounded.
ELECTRICAL REQUIREMENTS
The electrical requirements are a 120 volt 60 Hz, AC only, 20 amps. It is recommended that a separate circuit
serving only the oven be provided. The oven is equipped with a 3-prong grounding plug. It must be plugged into
a wall receptacle that is properly installed and grounded.
EXTENSION CORD
1.
2.
If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug
and a 3-slot receptacle that will accept the plug on the microwave oven. The marked rating of the extension
cord shall be equal to or greater than the electrical rating of the appliance, or
Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or
serviceman install an outlet near the appliance.
RADIO OR TV INTERFERENCE
Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave
oven is on a different circuit, relocate the radio or TV as far away from the oven as feasible or check position and
signal of receiving antenna.
Notes:
If you have any questions about the grounding or electrical instructions, consult a qualified electrician or service
person. Neither Sunbeam nor the dealer can accept any liability for damage to the oven or personal injury
resulting from failure to observe the electrical connection procedures.