Samsung CS29A5HT8X/BWT - Manual (Page 17)

Alignment and Adjustments
Samsung Electronics 4-5
4-8 Factory Adjustment
1. To enter the “Service Mode”, Press the remote-control keys in this sequence :
- If you do not have Factory remote-control
- If you have Factory remote-control
2. After the Service Mode is entered, the initial screen is as shown in the figure below.
*
Service
Deflection
Video Adjust 1
Video Adjust 2
Video Adjust 3
Option(81h 0Ch)
Reset
G2-Adjust
Others
3. Use the Channel Up/Down buttons to move the cursor in the adjustment parameters.
- When CRT, CRT PCB, FBT, E 2 PROM (sometimes MICOM) is replaced, the adjustment values
should be controlled.
- After the Service adjustment is completed, Do not select “Reset” in the service mode menu.
(After above procedure is done, power is on initially and the “Plug and Play” will be operated.)
PICTURE OFF PICTURE ON DISPLAY ( ) MENU MUTE
PICTURE ON DISPLAY ( ) FACTORY
4-8-1 Service Mode
* These hexa digits are check sum value which
depends on the MICOM.
If check sum value is changed, the value of
E
2 PROM Data newly initialed.
Note 2.
www.rtv-horvat-dj.hr