Samsung ML--6100 - Manual (Page 62)

4. 9 Printing
CONFIG
Use this tab to control the following printer features:
•
Power Save determines the length of time the printer waits after a job
is printed before it goes to a reduced power state. If the printer is used
frequently, select
OFF which keeps the printer ready to print with the
minimum warm-up time. This uses more electricity to keep the printer
warm and ready to print.
• Econo Mode determines the toner quantity the printer should use
when printing. If set to ON , the printer conserves toner when printing.
The default value is OFF , which provides 100% usage.
• Auto Continue determines what action the printer should take when a
manual feed print job is sent to the printer and there is no paper in the
MP Tray. If set to
ON , the printer will pick up the paper from cassette
after fifteen seconds. Otherwise, the printer will wait for you to load
paper in the MP Tray.
• Jam Recovery determines what action the printer should take when a
paper jam occurs. When set to OFF , the printer does not reprint a page
that has jammed. When set to ON , the printer keeps the image in
memory for a printed page until the printer signals that the page has
successfully printed. The printer reprints all jammed pages.
• Altitude helps the printer optimize its output depending on the air
pressure of the region. If you are close to sea level, it should be set to
“Low.” If at a high elevation (1,500 m / 5,000 ft or higher), set it to
“High.”
JOB
Use this tab to control the following printer features:
•
Timeout determines the amount of time (in seconds) the printer will
wait before printing the last page of a print job that does not end with a
command to print the page or a formfeed character. Valid range is
0 to
300 seconds .
• Paper Type provides the printer with information about the type of
paper to be used for a print job. If you use paper with a weight of more
than 42 lb. (90 g/m
2 ), or an envelope, set this to Thick and use the MP
Tray’s manual feed slot. Otherwise use the Normal setting.
• Toner Density determines the overall density of the printed image.
Valid selections are Light , Medium and Dark .
• Image Quality mode makes the printer optimize the print quality to
1200 dpi image quality.