Sunbeam 3112 /Y - Manual (Page 4)

Before cleaning UNPLUG THE CORD FROM OUTLET. To insure proper sanitation, the Pop
module should be detached and cleaned thoroughly in the dishwasher or in warm, sudsy
water at regular intervals. The motor housing wipes easily using a damp cloth. NEVER IMMERSE
THE MOTOR HOUSING IN WATER.
MAKE SURE THE HANDLE IS IN THE UPRIGHT POSITION. Unplug the can opener. Hold the can
opener with both hands and firmly press down on the eject button. (see Diagram A) Pull the
module out using the magnetic arm.
To replace the POP Module grip the unit with both hands and firmly push the module
with magnet side facing out into the unit. (See diagram B)
cord as required to reach the outlet.
The motor and internal gears of your can opener unit are permanently lubricated at the factory for
lifetime service and require no further attention. The cutting blade is made of hardened steel and
is a special design. It will last for years under normal use. 00 not attempt to sharpen and any
other maintenance should be performed by an authorized service representative.