Usb parameter defaults, Usb parameter defaults -4 – Symbol Technologies DS 3408 User Manual

Page 110

Advertising

DS 3408 Product Reference Guide

8-4

To set up the digital scanner:

Interface cables vary depending on configuration. The connectors illustrated in

Figure 8-1

are examples only.

The connectors may be different than those illustrated, but the steps to connect the scanner remain the
same.

Connect the modular connector of the USB interface cable to the cable interface port on the digital scanner (see

Installing

the Interface Cable on page 1-4

Plug the series A connector in the USB host or hub, or plug the Plus Power connector in an available port of the IBM SurePOS
terminal.

Select the USB device type by scanning the appropriate bar code from

USB Device Type on page 8-5

On first installation when using Windows, the software prompts to select or install the Human Interface Device driver. To
install this driver, provided by Windows, click Next through all the choices and click Finished on the last choice. The digital
scanner powers up during this installation.

To modify any other parameter options, scan the appropriate bar codes in this chapter.

If problems occur with the system, see

Troubleshooting on page 3-3

USB Parameter Defaults

Table 8-1

lists the defaults for USB host parameters. To change any option, scan the appropriate bar code(s) provided in the Parameter

Descriptions section beginning on page

8-5

See

Appendix A, Standard Default Parameters

for all user preferences, hosts, symbologies, and

miscellaneous default parameters.