Sony HTR-6100 - Manual (Page 22)

masterpage:Left
lename[E:\SEM_Janet\Revision_HTR-6100\Revised
\J9040000_2342883122HTR6100CEL\2342883122\GB04BSC_HTR-6100-CEL.fm]
22 GB
model name1[HTR-6600]
model name2[HTR-6100]
[2-342-883-12(2)]
A ; DIGITAL: Lights up when the receiver is
decoding signals recorded in the Dolby Digital
format.
B DTS: Lights up when DTS signals are input.
C SW: Lights up when the audio signal is output
from the SUB WOOFER jack.
D Playback channel indicators: The letters
(L, C, R, etc.) indicate the channels being
played back. The boxes around the letters vary
to show how the receiver downmixes the
source sound.
L (Front Left), R (Front Right), C (Center
(monaural)), SL (Surround Left), SR
(Surround Right), S (Surround (monaural or
the surround components obtained by Pro
Logic processing))
Example:
Recording format (Front /Surround): 3/2
Sound Field: A.F.D. AUTO
E Tuner indicators: Lights up when using the
receiver to tune in radio stations, etc. See
pages 17–21 for tuner operations.
F D.RANGE: Lights up when dynamic range
compression is activated (page 26).
G COAX: Lights up when the source signal is a
digital signal being input through the COAX
terminal.
H OPT: Lights up when the source signal is a
digital signal being input through the OPT
terminal.
I LFE: Lights up when the disc being played
back contains the LFE (Low Frequency
Effect) channel and the LFE channel signal is
actually being reproduced.
J ; PRO LOGIC II: “; PRO LOGIC” lights
up when the receiver applies Pro Logic
processing to 2 channel signals in order to
output the center and surround channel
signals. “; PRO LOGIC II” lights up when
the Pro Logic II Movie/Music decoder is
activated.
Note
Dolby Pro Logic and Dolby Pro Logic II
decoding do not function for DTS format signals.
About the indications in the display
MEMORY L C R
SL S SR
SW
L F E
ST
D.RANGE MONO
RDS OPT COAX
DIGITAL ;
PRO LOGIC II
DTS
;
9 q;
2 1 4 3 5
6 7 8
L C R
SL SR
GB01COV_HTR-6100-CEL.book Page 22 Tuesday, September 7, 2004 11:41 AM