Section 13: health and safety information, Health and safety information – Samsung Behold Series User Manual

Page 159

Advertising
background image

Health and Safety Information 156

Section 13: Health and Safety Information

This section outlines the safety precautions associated with using your phone. These safety precautions should be

followed to safely use your phone.

Health and Safety Information

Exposure to Radio Frequency (RF) Signals

Certification Information (SAR)

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the exposure
limits for radio frequency (RF) energy set by the Federal Communications Commission (FCC) of the U.S.
government.

These FCC exposure limits are derived from the recommendations of two expert organizations, the National
Counsel on Radiation Protection and Measurement (NCRP) and the Institute of Electrical and Electronics Engineers
(IEEE).

In both cases, the recommendations were developed by scientific and engineering experts drawn from industry,
government, and academia after extensive reviews of the scientific literature related to the biological effects of RF
energy.

The exposure limit set by the FCC for wireless mobile phones employs a unit of measurement known as the
Specific Absorption Rate (SAR). The SAR is a measure of the rate of absorption of RF energy by the human body
expressed in units of watts per kilogram (W/kg). The FCC requires wireless phones to comply with a safety limit of
1.6 watts per kilogram (1.6 W/kg).

The FCC exposure limit incorporates a substantial margin of safety to give additional protection to the public and to
account for any variations in measurements.

SAR tests are conducted using standard operating positions accepted by the FCC with the phone transmitting at its
highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified
power level, the actual SAR level of the phone while operating can be well below the maximum value. This is
because the phone is designed to operate at multiple power levels so as to use only the power required to reach
the network. In general, the closer you are to a wireless base station antenna, the lower the power output.

T919 Roxy.book Page 156 Thursday, September 25, 2008 5:01 PM

Advertising
This manual is related to the following products: