Savin 1232 User Manual
Page 102
Appendix
98
8
[Insufficient memory. Close all applications, then re-
start scanning.]
Close unnecessary applications running on
the computer.
[Insufficient memory. Reduce the scanning area.]
• Reset the scan size.
• Lower the resolution.
• Set with no compression.
Note
❒ The “The Relationship between the Reso-
lution and the Scanning Area” chart in
Help for halftone scanning might not al-
ways apply. Scanning cannot be per-
formed if large values are set for brightness
when using halftone or high resolution.
❒ When a paper misfeed occurs in the ma-
chine during printing, scanning cannot be
performed. In this case, after the misfed pa-
per has been removed, proceed with scan-
ning.
[No response from the scanner.]
• Check whether the machine is connected to
the network correctly.
• The network is crowded. Reconnect after a
while.
[No User Code is registered. Consult your system
administrator.]
Access is restricted with user codes. Consult
the system administrator of the machine.
[Please call your service representative.]
An unrecoverable error has occurred in the
machine. Call your service representative.
[Please wait]
The machine is in warming up. Please wait.
Automatic scanning will start soon.
[Scanner is in use for other function. Please wait.]
A function of the machine other than the scan-
ner function is being used such as the copy
function. Wait for a while and reconnect.
[Scanner is in use by other user. Please wait.]
Another user is using the machine to scan
originals. Wait for a while and reconnect.
[Scanner is not available. Check the scanner connec-
tion status.]
Check whether the machine is connected to
the network correctly.
[Scanner is not ready. Check the scanner and the op-
tions.]
Check whether the ADF cover is closed.
[The name is already in use. Check the registered
names]
You tried to register a name that is already in
use. Use another name.
[The scanner power is off.]
• Check whether the main power switch of
the machine is turned on.
• Check whether the machine is connected to
the network correctly.
Message
Cause and Action