Samsung BSP-4007 - Manual (Page 23)

22 Multi-Measurement Options
Multi-Measurement Options
a.
b.
c.
d.
e.
f.
g.
Setting Multi-Measurement
Press the MODE button repeatedly until the figure below shows
on the screen.
Press " " to select 1, 3 or 5 measurements. When set to 1 the
reading is a typical single measurement.
Press "MODE" button ("60" starts flashing).
Press "
" to set/adjust the time between readings; 60, 120 or
180 seconds. If you choose 3 readings at 120 seconds, there
will be 120 seconds between reading 1 and 2 and another
120 seconds between reading 2 and 3.
Press the START/STOP button to start measurements.
The monitor will show 2 bars (--) on the Systolic and Diastolic
display when each measurement ends.
After all measurements have been taken, the middle reading of
each Systolic, Diastolic and Pulse reading will be displayed on
the screen.
This allows the monitor to take 3 or 5 readings set at 60, 120
or 180 seconds apart. Similar to what your doctor may do.