ScyTek Electronics GALAXY G40RS - Manual (Page 3)

Remote Transmitter Description
The G40RS is a state-of-the-art remote starting system is supplied with two 4-button Remote
Transmitters used to control system operations.
The built-in remote start feature is designed to offer maximum convenience by remote starting your
vehicle’s engine, turning on the heater/air conditioner, and then running for a pre-determined time to
provide a comfortable environment once you enter your vehicle.
ScyTek Electronics Inc. and its VENDORS shall not be liable for any accident resulting from the use of this
equipment. This system is designed to be professionally installed into a car or vehicle in which all items,
such as parking brake and all associated components, Hood switches, transmission shift linkage, throttle
linkage, and all engine safety features, are in perfect working condition.
Do not ever Install G40RS in vehicles equipped with MANUAL TRANSMISSION.
DO NOT remote start the vehicle in a closed garage. Make sure that the garage door is open or there is
adequate ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon. To
ensure the safety and security of the system while it is remote started, the G40RS Starter employs several
safeguards. In the event the brake pedal is pressed while the engine is remotely running, the remote
start will immediately shutdown to prevent unauthorized users from attempting to drive the vehicle. The
system is equipped with a hood pin input to prevent access to the engine compartment while the vehicle
is remotely running. Finally, the Valet Mode prevents the remote start feature from operating in the event
the vehicle is to be serviced.
Button 1 Locks the doors and when held for 5 seconds, activates the system’s Car locator feature.
Button 2 Unlocks the doors.
Button 3 Feature programming only.
Button 4 Activates and deactivates the Remote Start feature.
Page 2 - G 40RS
Remote Transmitters
Button 1
Button 2
LED
Button 3
Button 4