Schutt Sports C2000 - Manual (Page 17)

C1000 & C2000 Assembly Instructions
17 www.schuttsports.com 800-426-9784
Backboard Attachment
Backboard and Rim Leveling
Step 1: Lift backboard assembly (1) up
and insert extension post (2) between
slider post brackets (3). Align
extension post rear holes with slider
post bracket top rear holes.
Step 2: Insert 1/2" x 3-1/2" bolt (4)
through holes and attach nut. Tighten
nut and verify that backboard assembly
pivots freely. Loosen nut as needed to
allow pivot action.
Step 3: Pivot backboard assembly up
and align extension post holes (5) with
slider post bracket holes.
Step 4: Insert 1/2" x 3-1/2" bolt through
holes, and attach washer and black
knob (6). Hand tighten knob.
Step 5: Insert 5/16" x 3-1/2" bolt through
backboard frame and extension post,
and attach nylock nut. Snug tighten nut.
Step 6: Remove strap that holds slider
post in place.
Step 1: Verify that backboard is level
horizontally and vertically and that goal
is level horizontally using a carpenter's
level. If adjustments are necessary,
proceed to next step.
NOTE: Backboard and goal leveling
requires the loosening and then the
retightening of different backboard,
brace, and goal hardware
combinations.
Step 2: First, loosen appropriate
hardware, and level backboard and
goal horizontally.
Step 3: Second, loosen appropriate
hardware, and level backboard
vertically by adjusting braces.
Step 4: Tighten all fasteners and attach
net to rim.
1
3
2
4
5 6