Sony MSW-A2000P - Manual (Page 25)

1-19 MSW-A2000
MSW-A2000P
Cable
Lower control panel unit
PANEL SELECT switch
Front switch panel
Lower control panel unit
BVTT3 x 6
BVTT3 x 6
Lower control panel unit
Release lever
Release lever
Cable
Cable holder
Connector
Back view
1-12. Removing/Reattaching Lower Control Panel Unit
1-12. Removing/Reattaching Lower
Control Panel Unit
The lower control panel unit is detachable from the main
unit, therefore operation with placing the single panel unit
on the table as a keyboard of a personal computer is
possible. (The length of the connected cable is about 62
centimeters.)
Not only connecting the cable to a CONTROL PANEL
connector in the front switch panel, but connection be-
tween the cable and a CONTROL PANEL connector in the
rear connector panel provides operating the lower control
panel. After connection, set a PANEL SELECT switch on
the switch panel as follows:
Connector to be connected Setting of PANEL
to lower control panel unit SELECT switch
Front (on the switch panel) FRONT side
Rear (on the connector panel) REAR side
Settings when connecting the two lower control
units
When connecting the two lower control units to one MSW-
A2000/A2000P, select which operation to enable by
setting from the setup extended menu ITEM-117.
Operation Setting of ITEM-117 Setting of PANEL
enabled SELECT switch
Front-side panel EXT or PARA FRONT side
Rear-side panel EXT REAR side
Both panels PARA REAR side
n
ITEM-117’s factory setting : EXT
Removal/Extension of the Lower Control Panel
Unit
1. After pressing the release levers, open the lower
control panel as shown in the figure below.
2. Disconnect the cable from the connector on the back
side of the lower control panel unit and from the cord
holder.
3. Remove the two screws shown in the figure.
4. Lightly draw the lower control panel unit toward you,
and then lift it upward.