Summit FS-60 - Manual (Page 8)

Changing the Direction of Opening the Door
If the door opening direction does not suit you, it may be changed to the opposite
side of the cabinet were holes are already made.
• Before changing the door the front side of the appliance must be slightly
raised.
• If the screws are covered with caps take them off before undoing the
screws.
• The lower hinge (2) can be removed by unscrewing the hinge and
removing the nuts (8) from the appliance.
• Then remove the door.
• Push the kick plate into its new position.
• Unscrew the upper hinge pin (1)
• Change the positions of the pins (5) and the door bearings, (7) at the top
and the bottom.
• Slip the door on the upper hinge pin (1).
• With the screws and nuts fix the lower hinge.
• Make sure the refrigerator is leveled so that it doesn’t fall.
• Unscrew the handle and place it on the opposite side of the appliance (it
cannot be done with handles mounted horizontally).
• At last check the resting of the magnetic seals (the seal must not be
creased and should seal well).
Instructions for Use