Sz1240 – Samson POWER AMPLIFERS SZ1240 User Manual

Page 2

Advertising

SZ1240

ARCHITECT’S & ENGINEER’S SPECIFICATIONS

The Samson SZ1240 shall be a 2 space rackmount single
channel power amplifier. It shall deliver 240 watts into 4
ohms or it shall be used for 25, 70, or 100 volt operation
utilizing internal output transformers. It shall have XLR
balanced inputs and XLR link output for second amplifiers.
It shall have a ground lift for pin 1 on the rear panel link
output. It shall have a selectable 400Hz high pass filter
and -12 to 0 dB gain adjustment on the rear panel. It shall
have a 4 ohm output on a Euroblock connector and have
25V, 70V, and 100V taps for constant voltage intergration.
It shall have a front panel power switch with power LED.
It shall have 4 LED indicators for signal, -20dB, clip, and
protect on the front panel. The SZ1240 shall have an internal
fan and tunnel cooling system plus multi-stage protection
for power-up,

overheating, over-current, short circuit, low

output impedance and DC voltage. The SZ1240 shall
get its power from standard IEC power cable for 115
volt operation or it can operate from DC24 volts via the
supplied Euroblock connector. The SZ1240 shall carry
a 3 year extended warranty.

SZ1360 SPECIFICATIONS

Rated Output Power

(at T.H.D 1.0%, 1kHz)

4 Ohm, ............................. 240 W

Gain Control .................................... -12dB to 0dB
Input Sensitivity ............................... (at Balanced Line)

1.0 ±0.1Vrms 10Kohms

High-pass Filter(at 400Hz) -3dB

... 12dB per Octave

Frequency Response ......................... +1.5 / -3dB at 70Hz-18kHz
Signal To Noise Ratio ........................ Better than 90 dB
THD at 1/2 rated output, 1kHz.............Less than 1.0%
Cooling.................. .......................... Variable speed fan
Operating Temperature/Humidity.........0°-40°C at 95% non-

......................................... condensing

Power Consumtion at full power ......... 361Watts

Power Requirement ..........................

AC100V~240V, 50/60Hz

.................................... and/or DC24V

Dimensions (W x D x H) .................... 19

˝ x 13.25˝ x 3.5˝

483mm x 292mm x 44mm

Weight ............................................ 37.4 lbs (16.9 kg)

PRODUCT SPECIFICATION SHEET

SERIES

DESCRIPTION