Stewart Filmscreen Corp B - Manual (Page 15)

Luxus A/SR-1 Electriscreen: Owner’s Manual 13
Installing the infrared remote control option
The optional Stewart Filmscreen infrared remote control allows control of
the screens from anywhere in the room.
Note: The distance between the hand-held remote control and the receiver
can be up to 50 feet. It is necessary to have uninterrupted line-of-sight
between the remote and the receiver.
Preparing the connection
Before making the electrical connections, you need:
‹ An available 120V AC constant power source
‹ A 4-conductor switch hook-up cable (4-conductor bell wire or
category 5 cable is typically used for long runs)
Making the connection
Refer to the diagram that is located on the white label inside the steel
housing, and in Figure 11.
1. Mount the low-voltage control box near the screen.
2. Mount the infrared (IR) eye sensor near the screen.
3. Connect the low-voltage control box to the screen by connecting
the screen motor power leads to the power strip terminal block
located on the circuit board of the control box.
4. Connect the IR eye sensor to the small black plug in module
located next to the switch input on the circuit board.
5. Connect the low voltage control box to the 120V AC power
source by connecting the AC line voltage to the power strip
terminal block located on the circuit board of the control box.
6. Connect the switch to the low-voltage control box.
Figure 11: Infrared remote control wiring
Low Voltage Control Box
3-Button
Momentary Switch
Infrared Sensor
Infrared Remote Control 120V AC
Line
R/F Input
InfraRed Input
Low Voltage
Switching
Neutral
COMMON-White
UP-Red
DOWN-Black
STOP-Yellow
COMMON-White
UP-Red
DOWN-Black
4 Conductor Hook-up Cable - 20ga Minimum
Category 5 recommended (NOT Supplied)