Sagem SAGEMFAST 1500WG - Manual (Page 97)

4 - Configuring the SAGEM F@st™ 1500 ADSL router
SAGEM F@st™ 1500 Reference Manual - 288053220-04
Reproduction and communication prohibited without the written permission of E E E E Page 4-51
4.9.3 Routing Table
Parameter Description
Flags Indicates the route status:
C = Direct connection on the same subnet.
S = Static route.
R = RIP (Routing Information Protocol) assigned route.
I = ICMP (Internet Control Message Protocol) Redirect route.
Network Address Destination IP address.
Netmask The subnetwork associated with the destination.
This is a template that identifies the address bits in the destination address used
for routing to specific subnets. Each bit that corresponds to a “1” is part of the
subnet mask number; each bit that corresponds to “0” is part of the host number.
Gateway The IP address of the router at the next hop to which frames are forwarded.
Interface The local interface through which the next hop of this route is reached.
Metric When a router receives a routing update that contains a new or changed
destination network entry, the router adds 1 to the metric value indicated in the
update and enters the network in the routing table.