Sharp MD-MT20H - Manual (Page 21)

20
ABOUT TRACK NUMBERS
When recording from analogue inputs:
(Including digital inputs other than
CDs or MiniDiscs)
A new track number will automatically be
created whenever 1 second or more of si-
lence occurs in the source.
(Auto marker function)
When recording, track numbers will be
created automatically.
(Auto marker function/Synchro marker
function)
● If there is some noise in the “silent”
spaces from the source, the track num-
bers may not be created at the correct
position, depending on the contents of
the source being recorded.
● You can also record a series of tracks
without using the auto marker function.
When recording from digital inputs:
(CDs/MiniDiscs only)
Track numbers will be created automatically
for each track at the same point where track
numbers already exist on the CD or
MiniDisc.
(Synchro marker function)
● The track numbers on the playback side
may not match the track numbers re-
corded on the MiniDisc.
● When recording, if a programmed play-
back is performed by the source or play-
back is performed by selecting tracks
manually, the MiniDisc track numbers
may not be the same as on the source.
● The track numbers can also be changed
after recording.
● Track numbers may not be created,
even when recording from digital inputs,
depending on the CD player used for the
source.
Playback
side Silence
Second
track
About 1
second
First
track
Recording
side
Playback
side
Recording
side
First track Second track Third track
Track A Track B Track C
First track Second track Third track
Track A Track B Track C
* MD-MT20H FOR UK(01-21) 99.3.11, 2:29 PM 21