Sony PCLink - Manual (Page 4)

4
-GB
Getting Started
Getting your PCLink going is as simple as plugging it into a primary
USB port of any computer running Windows 98, Windows Me,
Windows 2000, or MacOS 9.04. There is no need to load any special
software, but you will have to follow a few simple steps. After you
have finished these steps, make sure to read our tips on recording
before launching into a full session.
Windows 98/Me(Millennium edition)/
2000 Users
Windows Installation
Windows 98 installation
Note
Some computer systems ship with an OEM version of Windows 98 that does
not contain the entire generic USB driver and audio platform. If you
experience any trouble loading the USB drivers, please refer to the
troubleshooting section at the end of this user manual for further instructions.
1
There is no need to turn your computer off when plugging the
PCLink in for the first time. Locate your computer’s USB port
and plug the supplied USB cable in. Now plug the PCLink into
the other end of the USB cable.
2
Windows 98 will open an Add New Hardware Wizard and let
you know it’s found the PCLink. It will then start loading drivers
for a USB Composite Device, USB Human Interface Device, or
USB Audio Device, depending on what components have
previously been installed on your system. Click Next.
3
Check the option Search for the best driver for your
device (Recommended) and click Next.