Sony VPH-V20M - Manual (Page 13)

Projecting
13
You can also use the buttons on the control panel with the same names as
those on the remote commander to operate the projector.
1
Press down the MAIN POWER switch of the projector (O ON).
2
Turn on the power by pressing the 1/u (power on/standby) button.
3
Turn on the connected equipment.
4
Press the INPUT SELECT button to select the input signal to be
projected.
VIDEO: to select the signal input from the VIDEO IN VIDEO
connector
S VIDEO: to select the signal input from the VIDEO IN S VIDEO
connector
INPUT A: to select the signal input from the INPUT A connectors
To project the RGB or component signal, press the PAGE button
until the SYSTEM PRESET display appears. Press the
V or v
button to select INPUT A and select RGB or COMPONENT with
the
B or b button.
MUTING
INPUT SELECT
PIC
VIDEO S VIDEO INPUT A
TEST
R CENT B CENT PAGE
M SEL ASPECT RESET
1
4
2
Projecting
PIC MUTING button
ASPECT button