PS Engineering PMA8000-SR with Built-In SIRIUS Satellite Radio - Manual (Page 23)

PS Engineering
PMA8000-SR Series Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-880-0000 Page 2-15 Rev. 14, Oct. 2008
2.12.2 SIRIUS Satellite Radio ID number
The SIRIUS Satellite Radio identification number can be played back through the annunciation. Have a
pencil handy, and press “4-1-1” on the remote control.
2.13 Internal Recorder Checkout (Optional)
With headset plugged into pilot’s side jacks, tune COM 1 to local frequency, such as FSS or ATC ground.
Select Com 1 on mic selector switch, and record at least five incoming radio transmissions.
This audio should only appear in the pilot’s headset, and only be incoming transmissions from the trans-
ceiver selected in the mic select switch. Depress the panel or yoke mounted playback switch, and verify
that messages play, in the order received. Repeat for COM 2, and COM 3 (if installed).
2.14 Final Inspection
Verify that the wiring is bundled away from all controls and no part of the installation interferes with air-
craft control operation. Move all controls through their full range while examining the installation to see
that no mechanical interference exists. Verify that the cables are secured to the aircraft structure in accor-
dance with good practices, with adequate strain relief. Ensure that there are no kinks or sharp bends in the
cables and coaxial cables. Verify that the cables are not exposed to any sharp edges or rough surfaces, and
that all contact points are protected from abrasion.
Complete logbook entry, FAA Form 337, weight and balance computation and other documentation as
necessary. Sample text for FAA Form 337, and instructions for continuing airworthiness can be found in
Appendix F.
Return completed warranty registration application to PS Engineering or register online at www.ps-
engineering.com .