Simrad EQ60 - Manual (Page 58)

Simrad EQ60
46
857-164342 / Rev.C
3 Click the desired entry in the Frequency Channel
Selection list.
4 Select the alternative NONE in the Transducer Selection
list.
5 Click OK to accept the choice and exit the dialogue box.
6 Restart the echo sounder as described below.
Related topics
→
Transceiver Installation, page 112
To modify an IP address
This procedure allows you to modify the IP address of the
currently selected General Purpose Transceiver (GPT).
1 Select Transceiver on the Install menu.
2 Select Modify in the Transceiver Installation Mode
dialogue box.
- The Transceiver Installation dialogue box opens, and
you are allowed to make changes.
3 Select the General Purpose Transceiver (GPT) you wish to
modify.
4 Click the Set New GPT IP Address button.
- The
IP Address
dialogue box opens.
5 Enter the new IP address.
- The significance of the address numbers is described
with the
IP Address
dialogue box.
6 Click OK to accept the choice and exit the dialogue box.
7 Click OK to exit the Transceiver Installation dialogue
box.
8 Restart the echo sounder as described below.
Related topics
→
Transceiver Installation, page 112
→ IP Address, page 91
Restart the echo sounder
Whenever a change has been made to any of the frequency
channels, you must restart the echo sounder.
1 Select Operation on the File menu.
- The Operation dialogue box opens.
2 Select Normal operation, and click OK.
Related topics
→
Operation, page 97