Sharp FO-DC535 - Manual (Page 32)

Administrator Password
30
Administrator Password
The administrator of the machine can set a password to protect the settings
that are accessed with the key. When the password is set and
protection is enabled, the display will prompt you to enter the administrator
password each time you press to configure a MENU setting.
The administrator password is set using the operation panel as explained
below.
♦
If the Network Scanner Expansion Kit is installed as explained in Chapter 3,
the administrator password can also be set and enabled in the Web page
(see page page 84).
Setting an administrator password
MENU
MENU
1
Press the following sequence of keys:
, , , , , .
•
This is a hidden operation, and therefore error beeps may sound and the
display may not respond normally when you press several of the above
keys. Disregard the error beeps and display while pressing the keys.
•
If password protection (page 32) is already enabled, a password entry
screen will appear after you press . Continue to press the above
keys without entering the password.
2
Make sure that PASSWORD SET is
selected and press .
MENU
COPY
1
START/
ENTER
MENU
START/
ENTER
Display:
ADMIN PASSWORD
1:PASSWORD SET
2:PASSWORD PROTECTION
ADMIN PASSWORD
[ ]
ENTER OLD PASSWORD