Getting started, Setting up the hardware, Supplied software – Samsung SCX-4600 Series User Manual
Page 29: 29 setting up the hardware 29 supplied software
Getting started_ 29
3.
getting started
This chapter gives you step-by-step instructions for setting up the USB connected machine and software.
This chapter includes:
•
•
•
•
Installing USB connected machine’s driver
•
Supported optional devices and features may differ according to your
model. Please check your model name.
(See "Features by Models" on page 23).
SETTING UP THE HARDWARE
This section shows the steps to set up the hardware, as is explained in the
Quick Install Guide. Make sure you read the Quick Install Guide first and
follow the steps below:
1. Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow
extra space to open covers and trays.
The area should be well ventilated and away from direct sunlight or
sources of heat, cold, and humidity. Do not set the machine close to the
edge of your desk or table.
Printing is suitable for altitudes under 1,000 m (3,281 ft.). Refer to the
altitude setting to optimize your printing (See "Altitude adjustment" on
page 41).
Place the machine on a flat, stable surface so that there is no incline
greater than 2 mm (0.08 inch). Otherwise, printing quality may be
affected.
2. Unpack the machine and check all the enclosed items.
3. Remove all tape.
4. Install the toner cartridge.
5. Load paper (See "Loading paper in the tray" on page 47).
6. Make sure that all cables are connected to the machine.
7. Turn the machine on.
This equipment will be inoperable when mains power fails.
SUPPLIED SOFTWARE